Z-Uno - Z-Wave Board for Arduino Z-Wave.me


În Stoc
Cod produs:
Z-Wave Me

Not yet rated
Spune-ţi opinia


Z-Uno is the first and only easy to use developer board that allows you to create your own Z-Wave device without deep knowledge of Z-Wave protocol or programming. Z-Uno is a mix of Z-Wave home automation radio protocol power and Arduino simplicity. Being inspired by Arduino project Z-Uno inherits all concepts of easy-to-use hardware and software solutions, keeping maximum flexibility.

Z-Uno is a fully DIY product. It is made for those who are limited by existing choice of Z-Wave products and wants to extend their smart homes with more sensors and actuators: connect LEDs, buttons, switches, motors or any low voltage sensor including most of Arduino compatible sensors.

Z-Uno programming is done by writing sketch in simplified C language and loaded into Z-Uno using Arduino IDE. Many examples and comprehensive tutorials will help you to make your own project.


Being Z-Wave Plus certified device, Z-Uno is the perfect companion for you RaZberry gateway. Z-Uno is compatible with other controllers too: among them Fibaro Home Center 2/Lite, Vera Edge and Zipato Zipabox.


Primary Controller Compatibility
1 eeDomus+ Full Compatible
Fibaro Home Center 2 v4.160 Not Tested
Fibaro Home Center Lite v v.4.160 Not Tested
Vera Edge / Plus / Secure Not Tested
Zipabox/Zipaminicro/ZipaTile Not Tested
Piper / Piper NV (v.1.7.1) Not tested
Indigo Not tested
jeedom Full Compatible
Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 Full Compatible
Domoticz Not tested
OpenHAB Not tested
ZiHome Not tested
Tech Data
51 Power Supply USB 5 V, external 5V or 3 V, external 7-18 V or battery (via MU-2F connector, included)
52 Attachable Loads Defined by user: http://z-uno.z-wave.me/examples/Certified10Channels/
53 Explorer Frames - NWI Support Yes
54 SDK 6.51.06
56 Device Type Always On Slave
58 Z-Wave Alliance Product Link http://products.z-wavealliance.org/products/1825
90 Incluison Press Service button three times
91 Exclusion Press Service button three times
92 Factory Reset Hold Service button for five seconds, then press Service button three times. Use this procedure only if your controller is missing or inoperable. Note that the user sketch is not erased during exclusion or reset process.

Opinii (0)

Spune-ţi opinia

Notă: Codul HTML este citit ca şi text!

Rău            Bun


Z-Wave Romania

The On-line shop for home automation Z-Wave products. Based in Spain, we deliver all over the world. Z-Wave is the international standard for wireless networking of home control systems. You can manage lighting, electricity, blinds, alarms etc ... Z-Wave products from different vendors work well together allowing control of smart home.

Contact Us