€ 53,00
Descriere
Specificaţii
| Primary Controller Compatibility | |
|---|---|
| 1 eeDomus+ | |
| Fibaro Home Center 2 v4.160 | Full compatible |
| Fibaro Home Center Lite v v.4.160 | Full compatible |
| Vera Edge / Plus / Secure | |
| Zipabox/Zipaminicro/ZipaTile | |
| Piper / Piper NV (v.1.7.1) | |
| Indigo | |
| jeedom | |
| Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 | |
| Domoticz | |
| ZiHome | |
| Tech Data | |
| 53 Explorer Frames - NWI Support | yes |
| 54 SDK | 6.51.06 |
| 55 App Version | 3.2 |
| 56 Device Type | On/Off Power Switch |
| 58 Z-Wave Alliance Product Link | http://products.z-wavealliance.org/products/1734 |
| Procedures | |
| 90 Incluison | 1) Switch off the mains voltage (disable the fuse). 2) Place the Switch 2 within the direct range of your Z-Wave controller. 3) Connect the device in accordance with one of the diagrams attached in the manual. 4) After verifying correctness of the connection switch on the mains voltage. 5) Identify the S1 switch or the B-button (located on the device’s housing). 6) Set the main controller in (security/non-security) add mode (see the controller’s manual). 7) Quickly, three times press the S1 switch or the B-button. 8) Wait for the adding process to end. 9) Successful adding will be confirmed by the Z-Wave controller’s message. |
| 91 Exclusion | 1) Place the Switch 2 within the direct range of your Z-Wave controller. 2) Identify the S1 switch or the B-button (located on the device’s housing). 3) Set the main controller in remove mode (see the controller’s manual). 4) Quickly, three times press the S1 switch or the B-button. 5) Wait for the removing process to end. 6) Successful removing will be confirmed by the Z-Wave controller’s message. |
| 92 Factory Reset | 1) Switch off the mains voltage (disable the fuse). 2) Remove the Switch 2 from the wall switch box. 3) Switch on the mains voltage. 4) Press and hold the B-button to enter the menu. 5) Wait for the visual LED indicator to glow yellow. 6) Quickly release and click the B-button again. 7) After few seconds the device will be restarted, which is signalled with the red LED indicator colour. Use reset procedure only if the primary controller is missing or inoperable. |
| 93 Wake Up | The FIBARO Single Switch 2 is powered with mains voltage so it is always awake. |
