Universal Dimmer 250W Z-Wave+ Fibaro with metering


În Stoc
Cod produs:

Not yet rated
Spune-ţi opinia


The in-wall micromodule FGD-212 by Fibaro  will allow you to control a lighting system thanks to the Z-Wave protocol while maintaining your existing switch. You will therefore be able to operate a connected lamp and to vary its intensity using the existing switch, or iva a Z-Wave transmitter.

The new dimmer Fibaro FGD-212 is equipped with a smart detection algorithm of the light source which facilitates the configuration and ensures a high compatibility of the device. It has a self-protection against overloading and a soft start function. In the case of non-dimmable light sources, only the ON / OFF function is possible (connection with 3 wires system).

It is compatible with any type of lamps dimmables or not:

As a dimmer: -

  • Classic Light Sources Incandescent and halogen powered by 230VAC
  • 12V halogen lamps (with electronic transformers)
  • 12V halogen lamps (with ferromagnetic transformers)
  • LED Lamps dimmables
  •  Fluorescent Lamps CFL dimmables
  •  Using the Bypass with a source of dimmable light up in  225VA 2 wires mode connection (depending on load type)

As an On/off switch:

  • Fluorescent lamps
  • LED Lamps
  • Using the Bypass module with any light source its supports up to 225VA (depending on load type)

This module  can be used in 2 wires mode  (without neutral), replacing an existing switch, or three wires mode with a conventional power supply (phase + neutral). For lamps with very low power consumption (LED lamp, for example), you can use the Bypass moduel load  Fibaro FGB-001 that allows proper operation of the module.

In addition to the function variation, this micro-module can also measure the power consumption of the connected load. Instant consumption figures (in W) and total electricity consumption (kWh) can be consulted.

A Z-Wave controller (remote, control dongle, gateway ...) is necessary to integrate this module in your Z-Wave . Each Z-Wave module functions as a wireless repeater with other modules to ensure full coverage of your home.


  • Youo can manage a lighting system locally and in remote
  • Module can be installedbehind an existing switch
  • ON / OFF function and dimmer
  •  Use 2 wires mode neutral not required)
  • Integrates Z-Wave chip 500 series
  • Communication 250% faster compared to standard Z-Wave devices
  • Automatic load detection
  • Protected against overload
  • Compatible with Z-Wave and  Z-Wave Pluscontrollers
  • Function Measuring Active Power and Energy
  • Works with different types of switches - tappet, rocker, three-way, etc.
  • Soft start function (soft-start)
  • LED status indication of inclusion, and calibration levels
  • Z-Wave range tester integrated
  • Automatically detects wiring faults, high temperature, power surges and overloads
  • Advanced Configuration Options
  • Small, discreet and aesthetic
  • Ease of use and installation


  • Module Type: receiver Z-Wave
  • Power supply: 230V +/- 10%, 50Hz
  • Consumption: 1.3W
  • Wiring: neutral not required
  • Load capacity: 50-250W (resistive load) or 0.25-1.1A (inductive load)
  • Lamp type  compatible (dimmable): Incandescent, CFL, Halogen (230VAC and 12VDC with electronic transformer), LED
  • Lamp type compatible (not dimmable): CFL, LED
  • Frequency: 868.42 Mhz
  • Signal strength: 1mW
  • Transmission distance: 50m free field, 30m indoor
  • Dimensions: 42.5 x 38.25 x 20.3mm
  • Operating temperature: 0-35 ° C
  • Temperature limit: 105 ° C
  • Standards: RoHS 2011/65 / EU, LVD 2006/95 / EC, EMC 2004/108 / EC R & TTE 1999/5 / EC





Primary Controller Compatibility
1 eeDomus+ full compatible
Fibaro Home Center 2 v4.160 full compatible
Fibaro Home Center Lite v v.4.160 full compatible
Vera Edge / Plus / Secure full compatible
Zipabox/Zipaminicro/ZipaTile full compatible
Piper / Piper NV (v.1.7.1) Not Tested
Indigo Not Tested
jeedom full compatible
Domoticz full compatible
ZiHome Not Tested
Tech Data
50 IP Rating IP 20
51 FLiRS No
51 Power Supply 230V
52 Attachable Loads 25 ... 400 W, lower at very inductive or resistive loads.
53 Explorer Frames - NWI Support Yes
54 SDK 4.52.00
55 App Version 3.3
56 Device Type Routing Multilevel Switch
57 Peper1 Database link http://pepper1.net/zwavedb/device/334
58 Z-Wave Alliance Product Link http://products.z-wavealliance.org/products/1729
95 Generic Device Class Multilevel Switch
96 Specific Device Class Multilevel Power Switch
97 Routing Yes

Opinii (0)

Spune-ţi opinia

Notă: Codul HTML este citit ca şi text!

Rău            Bun


Z-Wave Romania

The On-line shop for home automation Z-Wave products. Based in Spain, we deliver all over the world. Z-Wave is the international standard for wireless networking of home control systems. You can manage lighting, electricity, blinds, alarms etc ... Z-Wave products from different vendors work well together allowing control of smart home.

Contact Us